Power steering is leaking from reservoir and power steering rack needs to be replaced for clunking noise and there is a coolant leak from water pump as well.
Just needed to be calibrated. Light is off now.
VSC light comes on when driving around left hand curves even when roads are dry
Remove all four wheels and inspect all four brake pads and rotors and remove rear brake rotors and/or drums to inspect parking brake condition. Inspect entire system for leaks. Reinstall all 4 wheels.
BRUCE H. gave our service a 5 star review on 3/29/2023
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
JOE M. gave our service a 5 star review on 3/28/2023
Replace brake pads and brake rotors. Clean and lubricate brake calipers and slide mechanisms. Road test vehicle.
Replace brake pads and brake rotors. Clean and lubricate brake calipers and slide mechanisms. Road test vehicle.
Mount and balance four tires, clean and bead seal all four rims. Install new rubber valve stems if needed.
STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
TIE ROD &/OR END – Remove & Replace – Inner,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
FOUR-WHEEL ALIGNMENT
Install LF axle
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
JOE D. gave our service a 5 star review on 3/28/2023
Fan won't shut off and is loud – customer will turn off after it vehicle is up to operating temp and then the fan doesn't turn on, RF windshield nozzle
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
ANDY H. gave our service a 5 star review on 3/27/2023
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. Check thermostat and electric cooling fan operation and test out
DANNY Z. gave our service a 5 star review on 3/21/2023