Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
ROTATE TIRES
BOB W. gave our service a 5 star review on 4/1/2021
Codes p1270 and p1635 codes indicate problem with fuel trim balance in RPM checked short-term and long-term trims they were staying positive around 10 or 15 check fuel pressure spec is 39 with engine idling only had 26 PSI which is too low with key on engine off I had too high of fuel pressure spec again is 39 we had 45 plus PSI upon inspecting fuel system found fuel pump driver module severely corroded and rotted onto hanging bracket replaced fuel pump driver module
FUEL PUMP CONTROL MODULE – Remove & Replace – [DOES NOT include test.]
SARAH C. gave our service a 5 star review on 3/28/2021
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Perform basic safety inspection.
Pre-purchase inspection
JOANNE L. gave our service a 5 star review on 3/19/2021
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Left – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Change oil and filter with full synthetic oil and check and top off all fluids and test out.
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. Check thermostat and electric cooling fan operation and test out
CARLOS C. gave our service a 5 star review on 3/12/2021